Metal spinning · Hand-hammered finishes · Tokyo, since 1961

Shaped from a single disc.
Finished by hand.

A flat sheet of copper or brass, spun on a lathe, eased into form by hand, then hammered until the light sits right on it. We are a small Tokyo workshop making lighting shades, vessels and architectural hardware — from a first prototype to runs of a few thousand.

Process

From disc
to form

  1. 01

    Cut the blank

    We cut a circular blank from copper, brass or stainless sheet, sized back from your finished dimensions. Gauges from 0.5 to 3.0 mm.

  2. 02

    Spin

    The blank turns on a lathe against a chuck, and the spinner works it down with a long lever tool. No press tooling — so runs can start at 30 pieces.

  3. 03

    Hammer

    Every mark is struck by hand. Hammering work-hardens the metal and breaks up harsh reflections into a soft, living surface.

  4. 04

    Finish

    Polished, brushed, blackened or verdigris. We choose the final colour for the light of the room it will live in.

At a glance

  • 1961

    Founded in Tokyo

  • Ø40–900mm

    Spinning diameter

  • 30pcs

    Minimum production run

  • 15days

    Working days to prototype

  • 14

    Countries shipped to

The company, people, figures and projects on this site are fictional.

Through the tip of the tool you can feel the metal asking for “a little more.” Knowing when to stop — that is the job.

— Master spinner, 38 years at the lathe (fictional)

Start with a single prototype.

No drawing yet? A sketch or a reference photo is enough to begin. We work in English, quote within three working days and ship worldwide — FOB Tokyo or DAP to your door.